Portfolio Category: Sludge Containers

The sludge container fitted with an auger is a specially designed container used mainly in water treatment plants. The container is fed through a chute on the roof. As the container fills the auger is turned on which distributes the sludge along container self levelling the sludge.

The Roll-on Roll-off flat body is designed to carry plant and machinery. The body is fitted with ramps and tie-down rings so machinery can be loaded and transported safely. The body is heavy duty and able to withstand the weight of heavy machinery.

At Numac we are always designing new containers to suit customer needs, our Two-Way door design was the result of this. The Two-Way door allows the door to be open to the side and also act like a tail door as seen on most tipper lorries. This has proven successful among contractors.

Containers fitted with sliding plastic lids have started to become more popular over the past few years. The lids fitted to the container are designed to keep all material inside dry. This is ideal to material such as plaster board which needs to be kept dry.

We have always designed and manufactured containers for the transportation of sludge waste. This particular container has been fitted with a PVC cover. Once container is filled then cover is fitted for transport. Container is partly covered at the rear to stop overspill when lifting.

This container is designed for wet sludge waste. Sludge is pumped into the container, once container is filled to capacity, a cut switch stops the pump or directs the waste to another container. This is proven successful as it doesn’t need constant monitoring.

With the continued growth of Bio-fuels, we have designed and built a Roll-on Roll-off container with a perforated floor which enables it to dry wood chip. The floor is removable so the container can be cleaned out.